Conventional lighting inside the most explosive pl

Conventional lighting inside the factory

introduction

the factory covers a variety of work nature and scope, from small workshops to large workshops, and the type of work is also changed from fine processing to heavy industry

introduction

the design of the workshop makes the lighting design relatively easy, but on the other hand, the special requirements put forward by the clumsy machine also form an obstacle for the lighting design. A well-designed lighting scheme can increase production, but it has just improved, reduce accidents, save production losses, and help workers improve their physical comfort

lighting scheme

there are three lighting systems for the internal lighting of the factory: conventional lighting, small area lighting and local lighting. Only conventional lighting and local lighting can exist independently. Small area lighting, as an auxiliary system, is a supplement to the main lighting when needed

conventional lighting

conventional lighting is designed to form a uniform illumination on the working surface of the entire lighting area, and the minimum average uniformity of 0.8 is acceptable

according to the installation height of lamps, straight tube fluorescent lamps, high-pressure sodium lamps, high-pressure mercury lamps and metal halide lamps can be selected as light sources

lighting level

work with no visual requirements - 200 to 300 lux

work with lower visual requirements - 200 to 300 lux

work with higher visual requirements - 750 to 1000 lux

installation height is less than 4 meters: the best lighting scheme is to install factory lighting reflectors on strip lamps or box lamps, and use a combination of fluorescent lamps and electronic equipment for lighting. Lamps are generally installed as discontinuous or continuous straight lines parallel to the observation direction. When low glare is required in the lighting area, lamps with shading plates with low glare performance can be used

the installation height is between 4 and 7 meters: fluorescent lamps can be used for the same lamps in the previous situation, high-pressure sodium lamps, high-pressure mercury lamps and metal halide (HPL-N, son or HPI) lamps, and medium bracket lamps with wide beam reflectors can be used. The use of the latter lamp can achieve the purpose of saving when the installation height is higher than 6 meters. You can choose which system to use according to the uniformity of lighting, light efficiency and the initial investment of the whole system

the installation height is more than 7 meters: it is very high in the workshop, an increase of 72% over the same period last year In other cases, high-pressure sodium lamp, high-pressure mercury lamp or metal halide lamp with power up to 400W can be used. Narrow beam reflectors can be installed on overhead lamps

local lighting

the use of local lighting can enhance the comfort of workers and reduce maintenance and energy consumption. In local lighting, fluorescent lighting is the best choice. You can choose lamps with factory lighting reflectors or lamps with waterproof performance of then closing the oil return valve. Using electronic ballast can effectively save electric energy

small range lighting

in some special work, the requirements for lighting grade and lighting quality are very strict. No matter from the technical feasibility or from the economic point of view, just using a single conventional lighting can not meet the lighting needs. In small-scale lighting, we often use fluorescent lamps and halogen lamps for lighting

product

conventional lighting

'tl'd light source tms-hf single reflector strip lamp

tmx-h is then equipped with TTX 400 relay system by crank rocker mechanism f

hpi-bu 250W, 400W MDK 900

son 150W, 250W, 400W SDK 900

hpl-n 250, 400W HDK 900

local lighting

'tl'd light source tms-hf single reflector slat lamps,

Pacific TCw

small range lighting

'tl'd light source tms-hf single reflector strip lamp,

Pacific TCw

halogen lamp, incandescent lamp table lamp (end)